Kit Contents:
VAD28 Multifunction Display with 2.8″ TFT Touchscreen
– Micro USB Cable
– 8GB Micro SD Card
– SD Card Adapter
– Wiring kit
– Mounting hardware
Many customers always ask: “Which values can I query from my control unit”. The answer: ” ALL “. The display is compatible with ISO 11898-2 and SAE J2284. Both CAN2.0A and CAN2.0B (ie 11 and 29 bit identifiers) are supported.
The control unit manufacturers themselves determine which values are sent via the CAN bus interface and document them accordingly. A total of up to 64 sensors can be queried if the manufacturer supports this. Further supported control devices can be found in our download area.
A small note on Megasquirt: all derivatives are supported here, such as KDFI, UMC1, Microsquirt etc. However, a CAN bus interface must be implemented.
In general, all control devices are supported that have a documented CAN bus interface. The manufacturers usually supply a “dbc” file which can then be converted for the display.
The following control units have already been tested:
– trijekt (Premium, Bee, trigifant) – trijekt plus with restrictions
– Megasquirt 2 and 3
– k-data KDFI
– UMC1 / UMC2
– Microsquirt
– EFIgnition
– MaxxECU
– EcuMaster Emu (standard with CAN , standard with Can Bus Adapter, Black)
– VAG (Audi / VW / Seat)
– van kronenburg KMS MD35 (MP25 with CAN bus adapter)
– LinkECU
– AEM EMS
– Motorsport Electronics ME442 and ME221 (the latter with adapter)
– MME ECU481 (with MME Can Bus adapter)
– VEMS (with serial adapter)
